18
17
V
in
V
out
Malla
Shield
Malla
Shield
A
HZ-
INT
SA
CTO
2C
A1
VP
MP
D
REF
RCPL-PLUS
LOTE
CODE
1
1758882
Colocar la parte superior de la regleta a 1,60m. del suelo.
Place the top part of the monitor connector at 1,60m. from the floor.
50mm.
50mm.
Presionar
para
abrir.
Press to open.
Ter, – and Malla (shield) are duplicated for easiest cascade installation of parallel
monitors or telephones. If the first monitor is not placed on the connector
, cascade units
will not be powered.
escription of the RCPL
-Plus
D
monitor connector
.
a
a
b
b
f
e
d
c
a. W
all attachment hole (x4).
b. Monitor attachment hook (x2).
c. V
ertical wiring input.
d. Attachment clip.
e. W
iring input hole.
f.
Installation terminals:
positive, ground.
video signal coaxial input.
coaxial shield.
video signal coaxial output.
audio communication.
digital communication.
door bell push button input.
intercom.
auxiliary calling device output.
video distributor activation output.
2nd camera activation output.
optional device activation output.
twisted pair video signal.
+, –:
Vin :
Malla:
V
out :
A :
D :
HZ
- :
INT :
SA :
CT
O :
2C :
A1 :
Vp, Mp :
L562 module for video installations
E
with twisted pair cable.
andling the end of line jumper.
H
hanging the front film.
C
The end of line jumper is placed on the CN4 connector
, that can be
located on the monitor base.
In case of twisted pair cable installations, the end of line jumper
is placed in the EL562 module, also located in the CN4 connector
of the monitor base.
Do not remove the jumper on monitors where the video cable finish.
R
emove the jumper on monitors where the video cable continue.
The monitor is supplied with a reversible front film, that allow the owner
to choose between two colors.
To
change the front film, remove the front plate by inserting a plain screwdriver
in the triangle marks, as it is shown on the drawing
.
MONIT
OR ADJUSTMENTS
MONIT
OR CONNECT
OR DESCRIPTION
Locate the CN4 connector
, that's placed in the monitor base.
R
emove the existing jumper and plug the EL562 module.
NO
TE
: on this type of installations the EL560 module must be
plugged in the EL500 microprocessed circuit (page 12).
R
efer to the specific installation diagram.
