golmar SAR-G2+, Instruction Manual

Page: 7 / 8

7
WIRING DIAGRAMS
Stairs light activation relay:
*
( )
Neutral point of the power supply of the stairs light is connected in series through the relay contacts of the SAR-12/24.
IMPORTANT: For the description, installation, configuration and programming of the system, see the corresponding manual.
Golmar additional alternating lock release relay:
IMPORTANT:
For the description, installation, configuration and programming of the system, see the corresponding manual.
RELAY UNIT TSAR-G2+
*
( )
220 Va / c
1.8A max.
SAR-12/24
F
N
IN IN
NC NA C
To stairs light
push button.
BUS (M) BUS(PL)
SAR-G2+
BUS BUS
C N.A N.C 12+
To monitors/
terminals
Important:
The minimum section of the cables
connecting the output terminals
of the relay SAR-
is 12/24 1,5mm2.
Lock release
max. 12 Vdc/270mA.
AP
NA2 + AP- C1 NA1 AP+ C2 AP+
GND
BUSBUS
Relé 2 Relé 1
_
12Vdc
NC2
CCTV
Access door panel
AP1
Mains
100~240Vac
FA-G2+
L N
ON
1 2 3 4
SAR-G2+ configuration SW1 dip switch:
Light mode: Dip 4 to ON. operating
Door panel 1: Dip 1 & 2 to OFF.
Dip 3: To OFF.
1 2 3 4 5 6 7 8 910
ON
JP1 jumper: Leave in the pos. 2-3.
*
( )
~ ~ ~ ~
Lock release 2
max. 12 Vac/850mA.
TF-104
Mains
PRI SEC
SAR-G2+
BUS BUS
C N.A AP1 N.C 12+
Access door panel
Lock release 1
max. 12 Vdc/270mA.
AP
NA2
+
AP- C1 NA1 AP+ C2 AP+
GND
BUSBUS
Relé 2 Relé 1
_
12Vdc
NC2
CCTV
Mains
100~240Vca
BUS (M) BUS(PL)
FA-G2+
L N
Fit the varistor supplied with the sound
o e directly to the lock release m dul
terminals.
( )
1
( )
1
ON
1 2 3 4
SAR-G2+ configuration SW1 dip switch:
Lock release 1 (door panel 1) operating mode:
Door panel 1: Dip 1 & 2 to OFF.
Lock release 1: Dip 3 to OFF.
ON
1 2 3 4
Lock release mode: Dip 4 to OFF. operating
Lock release 2 (door panel 1) operating mode:
Door panel 1: Dip 1 & 2 to OFF.
Lock release 2: Dip 3 to ON.
1 2 3 4 5 6 7 8 910
ON
Important: Must be configured in the SAR-G2+ the lock release
(1 or 2) that is not being used on the door panel.
AP1
Pressin g "AP1" activates the lock
release connected to the SAR-G2+
Relay Unit.
JP1 jumper: Leave in the pos. 2-3.
To monitors/
terminals