49
50
DOOR PANEL INSTALLATION
DOOR PANEL INSTALLATION
all tone selection.
C
Call tone 1
Call tone 2
5 P1 3
CVCV
~2~1
I I I I I I I
4
5
6
7
8
9 10
lug the Short connection cable.
P
0
7
0
7
Use the connection cable RAP-610A, for the connection of 2 push buttons
modules EL610A of different embedding boxes. Insert the connection
cable in the output connector of the last module EL610A of the first
embedding box and the other end of the connection cable in the input
connector of the first push buttons module EL610A placed in the top
part of the second embedding box, as shown in the drawing.
lug the connection cable RAP-610A.
P
*
*
Factory default
I I I I I I I
4
5
6
7
8
9 10
inal adjustments.
F
If after starting the system it
volume isn
't correct, proceed with the necessary
adjustments as shown
in the drawing
.
's considered that the audio
lace the nameplate labels.
P
Open the label holder.
Place the label and
close.
Once finished the works of wiring, configuration and
final adjustments, fix the frame in the embedding
box with the supplied screws.
lose the frame.
C
Between push buttons modules EL610A of the same embedding box,
insert the short connection cable of the output connector of the first
push buttons module to the input connector of the second push
buttons module, as shown in the drawing.
Insert the short connection cable that it is supplied with the product
EL610A, in the push buttons connector of the sound module EL651
and the other end of the connection cable in the input connector
placed in the top part of the push buttons EL610A module, as shown
in the drawing.
The sound module EL651, have a jumper placed on the back side and
on the left side of the terminal connector. This jumper allows to select
between two different call tones:
"
0
" call tone 1 (factory default) or "
7
" call tone 2.
This allows the user to distinguish where the call is comming from.
