6. TECHNICAL INSTRUCTIONS Cont’d
REMOVAL OF BURNERS
Remove screws from front fascia and rear of griddle plate to allow plate to be removed.
Remove the bolts from the rear of the burner and in the case of the GPG and GPGD
remove the heat baffle that is mounted on top of the burner throat. Lift the rear of the
burner up to clear the back support and at the same time pushing toward the rear until
the air shutter, which is attached to the throat of the burner, clears the injector. Allow
the front of the burner to drop down and whilst still holding the back of the burner up
pull towards the front.
CONTROLS
The only controls are the PEL 21S gas valves. All are accessible after the front
stainless steel fascia is removed (refer to attached pages for instructions on using gas
controls. If controls get hard to turn, get a service man to remove the two screws at
the front of the control and put a high temperature graphite grease on the shaft.
IM027B2/p9
