27.
Identify the Low Cable (72).
Route the Cable
through the Backrest Upright (8) and under a
110mm Pulley (59). Attach the Pulley inside the
Upright with an M10 x 93mm Button Bolt (97),
two M10 Washers (84), two 25mm Spacers (55),
and an M10 Nylon Locknut (79).
27
97
84
55
72
55
59
84
79
8
16
29. Route the Low Cable (72) under a 90mm Pulley
(58). Attach the Pulley and two Half Finger
Guards (40) to the Center Base (2) with an M10 x
46mm Button Bolt (100) and an M10 Nylon
Locknut (79).
30. Wrap the Low Cable (72) over a 90mm Pulley
(58). Attach the Pulley, a Small Cable Trap (63),
and two Half Finger Guards (40) to the second
hole from the bottom of the two Pulley Plates (74)
with an M10 x 53mm Button Bolt (147) and an
M10 Nylon Locknut (79).
Make sure that the
Cable Trap is oriented to hold the Cable in the
groove of the Pulley.
79
72
58
2
40
40
100
29
28. Route the Low Cable (72) over a 90mm Pulley
(58). Attach the Pulley and two Half Finger
Guards (40) to the Double “U”-bracket (46) with
an M10 x 46mm Button Bolt (100) and an M10
Nylon Locknut (79).
28
46
40
40
79
100
72
58
30
40
40
58
72
74
74
63
147
79
