7. Insert the Wire Harness (77) and the Console
Wire (66) into the Right Upright (107).
Set the console assembly on the Left Upright
(84) and the Right Upright (107).
Be careful to
avoid pinching the wires.
While a second per-
son holds the console assembly, attach it to the
Uprights with four Console Bolts (64) and four
Star Washers (8) as shown;
start all four
Console Bolts and then firmly tighten them.
Plug in the power cord as described on page
11, and turn on the power as described on page
13. Note: The treadmill may automatically rise to
the maximum incline level and then return to the
minimum level. Adjust the incline to the lowest
inline level as described in step 4 on page 13.
7
Console
Assembly
64
77, 66
64
8
8
107
84
6. With the help of a second person, carefully raise
the Uprights (84, 107) to a vertical position.
Have the second person hold the console as-
sembly near the Right Upright (107) as shown.
Look under the console assembly and locate
the console wire.
Remove the tie from the Wire Harness (77).
Connect the Wire Harness to the Console Wire
(66).
Make sure to connect the connectors
properly (see the inset drawing). The con-
nectors should slide together easily and
snap into place.
If they do not, turn one con-
nector and try again.
IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
6
107
Tie
77
66
Console
Assembly
77
66
8
5. Attach two Base Pads (82) to the Base (108)
with two 1” Tek Screws (83) as shown.
Insert the other Extension Leg (89) into the
Base (108) as shown. Hold two Extension Leg
Nuts (67) in the bottom of the Extension Leg.
Next, insert two Extension Leg Bolts (65) into
the top of the Extension Leg, and firmly tighten
the Extension Leg Bolts into the Extension Leg
Nuts.
5
89
82
82
108
83
65
67
84
