15
Setting the aspect ratio
You can change the aspect ratio of the input video signal (or the ratio of width to height of the
image).
To change the setting according to the type of the input video signal with the remote control :
•
Press any of the aspect buttons (Standard, 16:9, or ZOOM).
•
Every time the ZOOM button is pressed, the zoom mode changes from Zoom 1 to Zoom
2, to Zoom 3, and back to Zoom 1.
To stop a projection :
•
Press the POWER button on the projector or the OFF button on the remote control.
•
A confirmation message is displayed.
•
To cancel the procedure, leave the projector for a while or press the MENU button on
the remote control
•
To confirm the Power off, press the POWER button on the projector or the OFF button
on the remote control again.
•
The lamp goes out and the projector goes into a standby mode. In this standby mode,
the POWER indicator blinks red.
•
Wait about two minutes for the POWER indicator to be lit in red steadily.
•
During this period of two minutes in the standby mode, the intake fan and exhaust fan
rotate to cool the lamp. Do not turn off the main power switch of the rear panel while the
POWER indicator is blinking. Turning off the main power switch immmediately after use
may cause a breakdown.
•
Though the fan makes loud sounds during cooling, such symptom is not a malfunction.
