Goldline SAB Series, User Manual

Page: 15 / 20

Before Installation :
Before cutting into any bench tops, ensure the minimum clearances to walls, adjacent surfaces and overhead surfaces required by the
relevant gas appliance installation code (
see above
)
will comply
.
Dimensions are specified in millimeters
(
mm
)
Overhead cupboards and range hood
=
600 mm
.
Side and rear clearance
=
200 mm to any burner edge
.
Overhead exhaust
/
When
you have installed the hob, make sure that
The GPO (general purpose outlet) must always be in an accessible position.
The supply connection point, test point and natural gas regulator adjustment screw (for Natural gas installation
)
are accessible
for testing and
/
or adjustment with the hotplate in the installed position
.
TO BE INSTALLED ONLY BY AN AUTHORIZED PERSON
Place burner box Apply the adhesive sealing tape to the underside lip of the burner
box
.
Show
n at G opposite. Place burner box into cutout
hole and fit clamping brackets to clamp the hotplate to the bench.
Electrical connection. Install a 10 amp general purpose
outlet
(
GPO
)
i
n accordance with relevant electrical standards
and
/
o
r codes of
practice applicable. The power supply
cord
(
supplied
)
mus
t not touch against any hot surfaces and must be placed
so that its temperature does not exceed 75 degree at any point along its length. After having installed the
hotplate
,
th
e GPO must
always be in an accessible position.
GAS CONVERSION INSTRUCTIONS:
The manufacturers servicing instructions detail how authorized personnel may convert the
hotplate from Natural gas to LPG or from
LPG to Natural gas
.
Contact th
e manufacturer or agent as required.
Converting to a different gas type
When converting from LPG to NG ensure that the LPG test point is removed and replaced
with an approved NG regulator supplied in the kit. The test point pressure must be adjusted
to 1.00 kPa with the largest burner operating at on maximum flame.
GAS TYPE WOK
(OUTER)
WOK
(INNER)
SEMI RAPID AUXILIARY
LPG 1.10 0.50 0.69 0.50
NG 1.80 0.8 1.18 0.9
HKTG 3.00 1.45 1.75 1.30
Table of injector sizes.
Page 15