GoldenEar
Invisa Signature Point Source Manual
11
10. While holding in place, tighten the six lock arm screws with a screwdriver (Figure 7). This will rotate the
lock arms and secure the speaker to the wall/ceiling. DO NOT OVERTIGHTEN the lock arm screws as this
could damage the drywall. If you are using a power screwdriver or drill, set the torque to a value of no
more than 7 in.-lb (8dN-m).
11. Install the grille by placing it over the installed speaker and aligning the powerful miniature magnets.
Setting the Invisa Speaker’s High Frequency EQ Control (HF EQ Switch)
We suggest starting with the HF EQ control (Figure 9) in the center position, in typical rooms with a balance
of reflecting and absorbing surfaces. If, however, your listening room is overly “bright” due to many reflective,
hard surfaces, select the “-” position to effectively compensate for this type of room acoustics issue. If, however,
your listening room is filled with heavy furniture and fabrics or you are sitting fairly far from the speakers, making
the sound “dull”, select the “+” position to compensate for this type of room acoustics issue.
Setting Bass and Treble Controls on Receiver or Amplifier
Normally we recommend that you set the “Bass” and “Treble” controls on flat (or off, or 0 dB). Same applies
for a graphic equalizer; we recommend that you leave it flat (or off). This will give you the most accurate and
natural sound. If you want more bass, raise your subwoofer’s “Level” control (or raise the subwoofer level on
you’re a/v receiver), keeping in mind that even a little turn of the knob can make a big difference in the sound.
The reason for this recommendation is that we have discovered what is often thought to be improper sounding
speakers is, in fact, a problem caused by the use of tone controls. When in doubt, leave them out (flat); this almost
always results in the best possible and most natural sounding system performance.
Figure 9
TWEETER CAN BE ROTATED BY
REMOVING SCREW
(4 PLACES), PULLING TWEETER
ASSEMBLY OUT SLIGHTLY,
ROTATING IT 90º AND
SECURING IT IN PLACE AGAIN
BY REPLACING THE SCREWS.
Rotating Tweeter for Horizontal Installations
When installing the Invisa Signature Point Source
horizontally, as in a typical center channel application,
you must rotate the tweeter 90 degrees for proper
performance. See Figure 8.
Figure 8
Invisa PointSource_Manual_06_27_2021.indd 11
Invisa PointSource_Manual_06_27_2021.indd 11
6/27/21 1:22 PM
6/27/21 1:22 PM
