25
J. Putting on the ROOF COVER (Optional)
1. Place the ROOF COVER over the top of the sauna. Be cautious when
pulling the power cord through the hole in the roof cover. Gently place the
ROOF COVER onto the ROOF PANEL. When the edges are aligned,
screw the ROOF COVER to the roof panel. (see Figure 28)
Figure 28
Assembly Completed
Operating the Sauna
NOTE: Before the sauna is turned on, remove plastic protective covering from
the CONTROL PANELS. Please check and confirm that the connections to the
POWER SUPPLY (including the power cord), HEAT EMITTERS, CD/RADIO, and
TEMPERATURE SENSOR are connected properly and are snug and tight. The
power supply voltage and frequency must match the requested voltage and
frequency of the sauna (120VAC 20AMP Dedicated Circuit). Please consult a
certified electrician for any electrical modifications or repairs.
Since many materials absorb the infrared rays, minimal clothing is
recommended for maximum effect. The infrared sauna emitters are designed to
heat you and not necessarily the air inside the sauna. It is not a hot box like a
traditional sauna. The temperature gauge is a guide for your safety. It is
recommended that you drink water before, during, and after sauna use to
prevent dehydration since body fluids will be lost through perspiration. It is not
recommended to shower immediately after use since the pores in your skin will
be open and could possibly absorb anything in the water.
CAUTION: Exit Sauna Immediately If You Feel Dizzy, Sleepy,
Or Any Discomfort.