GM Electronics Ltd.
2. Switch the mode to
"MAN.GB"
3. Select sensitivity of the detector with
"SENSITIVITY"
and/or
additional gain of the received signal (
"BOOST"
switch).
4. Switch “On” the detector.
5. With the
"TRASH/GB"
potentiometer rotated clockwise or
counterclockwise, the detector will be adjusted to a sound
threshold, providing a quiet with a few hertz frequencies.
6.
Raise the antenna from the ground at the working height
(not less than 10 cm) and rotate
"TRASH/GB"
potentiometer
counterclockwise very carefully to find the best working sound
of the detector. It will be needed only a few position on the
scale.
7. The device is ready for use.
4.3 Manual tune in “AGEB” mode (max depth)
This mode is unique to the
Golden Mask Deep Hunter
PRO3se
. Unlike the
Golden Mask Deep Hunter PRO2
, where
manual and automatic soil elimination options were also
provided, the
Deep Hunter PRO3se
now is capable of
manually tuning ground balance in automatic ground balance
mode. This method allows simultaneous use of the advantages
of automatic "tracking" of the terrain from the AGEB system
and precise manually at the level of elimination of the influence
of the ground in a very bad soil conditions. It will give you the
max depth of the searching
To use this method:
1.
Place the antenna on the ground surface.
2.
Switch the mode to
"AGEB"
3.
Turn the
"TRASH/GB"
full left (many turns may needed) and
then set it to
“6”
position.
4.
Select sensitivity of the detector with
"SENSITIVITY"
and/or
additional gain of the received signal (
"BOOST"
switch).
5.
Turn
“On”
the detector.
6.
Press
“RETUNE”
and turn
the
"SENSITIVITY"
knob to
find the max value, which can be used.
7.
Raise the antenna from the ground at the working height
(not less than 10 cm) and rotate
"TRASH/GB"
potentiometer
counterclockwise very carefully to find the best working sound
Golden Mask Deep Hunter
pro3se
–
Instruction manual
7
