23
Xpeed LAN 500
Four possible scenarios
This section describes how to add and remove devices using HomePlug AV Simple Connect
Technology and covers some of the technical details of how the technology works.
Case 1: Forming a Network
Two devices with different network membership key (NMK) values are connected to the same
powerline. The user wants them to form a logical network.
1. Press each device
RESET/NET.ID button
for 5-8 sec till all LEDs re-flash to generate the
random network password key first.
2. Press RESET/NET.ID button on the first device for less than 3 seconds.
3. Press RESET/NET.ID button on the second device for less than 3 seconds. RESET/NET.ID
button on the second device must be pressed within 1 minute, by default however the interval
is programmable.
4. Wait for connection to complete and the
PLC LED
will be
ON
.
The PWR LED on both devices will flash evenly at 1-second intervals until the operation
succeeds or fails. It will illuminate steadily on successful completion. If an error occurs, the PWR
LED on the ‘adder’ will flash unevenly until the RESET/NET.ID button on the ‘adder’ is pressed
again or the ‘joiner’ is reset by holding the RESET/NET.ID button down for 10-15 seconds.
The join operation can be cancelled by pressing the RESET/NET.ID button on the first device
again, for less than 3 seconds, instead of pressing RESET/NET.ID button on the second device.
Summary of Contents for Xpeed LAN 500
Page 1: ...User s Manual...
Page 8: ...5 Xpeed LAN 500 5 Click I Agree button to continue 6 Click Install button to continue...
Page 9: ...6 Xpeed LAN 500 7 Click Finish button to continue 8 Click Next button to continue...
Page 11: ...8 Xpeed LAN 500 11 Click Next button to continue 12 Click Close button to exit...
