Golden Eagle Golden Eagle Wood Pellet Burning Stove, Operating & Installation Manual

Page: 25 / 39

Optional Thermostat
An optional thermostat may help you maintain a
constant house temperature automatically. The
control panel can be set up two ways to operate
your stove in thermostat mode.
THERMOSTAT INSTALLATION
A MILLIVOLT THERMOSTAT IS REQUIRED.

Unplug stove from power outlet.

Remove control board from stove.

The two thermostat wires connect to the
terminal block on the lower left side of the back
of the control board. (See figure 12)

Insert the wires in the terminal side and tighten
the two screws.
MODES OF OPERATION
TO SWITCH BETWEEN ANY OF THE THREE MODES
THE STOVE MUST BE SHUT OFF, THE NEW MODE
SELECTED, AND THE STOVE RESTARTED.
MANUAL MODE

USE THIS MODE EXCLUSIVELY IF YOU DO NOT
CONNECT AN OPTIONAL THERMOSTAT

In this mode the stove will operate only from the control panel as detailed in the “ OPERATION ”
section of this owner’s manual.
HIGH/LOW THERMOSTAT MODE

When engaged in this mode the stove will automatically
switch between two settings. When warm enough, it will
switch to the #1 or low setting. The room air blower will also
slow to its lowest speed.

The Heat Level Advance setting on the bar graph will stay
where it was initially set. When the house cools below the thermostat setting, the stove will
switch to the feed rate of the heat level advance setting.
ON/OFF THERMOSTAT MODE

In this mode when the home is warm enough the stove will shut off. The fans will continue to run
until the stove cools.

When the home cools below the thermostat setting, the stove will automatically restart and run
at the last feed rate setting.
When in “high/low” or “on/off” thermostat mode –

Set the heat level to the #3 setting.

Do not operate the stove higher than the #3 setting.

Set damper control rod approximately ¼” to ½” out. This will vary depending on your
installation. Observe stoves operation and adjust damper as necessary
Figure 11