SAFETY
For safety keep
fi
ring and ashpit doors tightly closed.
Do not connect this unit to a chimney
fl
ue serving another appliance.
Danger: Risk of
fi
re or explosion. Do not burn garbage, gasoline, naphtha, drain oil, or other inappropriate materials. Do not use
chemicals or
fl
uids to start the
fi
re.
Warning: Risk of
fi
re. Do not operate with
fl
ue draft exceeding .060 In/14.93 Water column. Do not operate with fuel loading and
ash removal doors open. Do not store fuel or other combustible materials within marked installation clearances. Inspect and clean
fl
ues and chimney regularly.
Caution: Hot surfaces. Keep children away. Do not touch during operation.
The heat exchanger,
fl
ue pipe, and chimney must be cleaned regularly to remove accumulated creosote and ash. Ensure that the heat
exchanger,
fl
ue pipe, and chimney are cleaned at the end of the heating season to minimize corrosion during the summer months.
The appliance,
fl
ue pipe, and chimney must be kept in good condition. These instructions also apply to a draft inducer if used. To
prevent
fl
ame or smoke spillage, the slide baf
fl
e must be pulled out and the fuel loading door left cracked for 10 seconds prior to
opening door fully. Load fuel carefully or damage may result. For canadian installations - not to be connected to a ductwork that
is still connected to another furnace.
Hot while in operation. Keep children, clothing and furniture away. Contact may cause skin burns.
Do not use chemicals or
fl
uids to ignite the
fi
re.
Do not leave the furnace unattended when the door is slightly opened.
Do not burn garbage,
fl
ammable
fl
uid such as gasoline, naphtha or motor oil.
Always close the door after the ignition.
Consult your municipal building department or
fi
re of
fi
cials about permits, restrictions and installations requirements in your area.
INSPECT FLUE PIPES, FLUE PIPE JOINTS, AND FLUE PIPE SEALS REGULARLY TO ENSURE THAT SMOKE AND FLUE
GASES ARE NOT DRAWN INTO, AND CIRCULATED BY, THE AIR-CIRCULATION SYSTEM.
CAUTION: CLEAN OUT OF THE HEAT EXCHANGER, FLUE PIPE CHIMNEY, AND DRAFT INDUCER, IF USED, IS
ESPECIALLY IMPORTANT AT THE END OF THE HEATING SEASON TO MINIMIZE CORROSION DURING THE SUMMER
MONTHS, CAUSED BY ACCUMULATED ASH.
