background image

Never use the appliance to dry clothes.

Always unplug appliance when not in use.

When the appliance has been unpacked, check it for transport damage and
ensure all parts have been delivered. If parts are missing or the appliance has
been damaged, contact the Customer Services Team.

Do not use if there are visible signs of damage to the appliance.

Do not connect the appliance to mains supply until completely assembled and
adjusted.

Ensure hands are dry before handling the plug or main unit.

Ensure appliance is on a flat, stable, heat-resistant surface.

Do not operate with cord set coiled up as a heat build up is likely, which could
be sufficient to become a hazard.

Carry out regular checks of the supply cord to ensure no damage is evident

Do not operate this appliance with a damaged cord, plug or after the appliance
malfunctions or has been dropped or damaged in any manner. Take to a
qualified electrical person for examination, electrical service or repair.

Do not twist, kink or wrap the cord around the appliance, as this may cause the
insulation to weaken and split. Always ensure that all cord has been removed
from any cord storage area and is unrolled before use.

It is recommended that this appliance is plugged directly into the wall socket.
Power boards are not rated to supply power to high wattage appliances.

A correctly specified, undamaged extension cord may be used with this
appliance provided it is used in a safe manner.

Do not remove plug from power socket until the appliance has been switched
off.

Do not remove plug from power socket by pulling cord; always grip plug.

Do not place cord under carpet or cover with rugs or furniture. Arrange the cord
so it cannot be tripped over.

Don’t

place appliance on bedding or on thick & long carpet where the openings

may get blocked.

Switch off and use handle provided when moving

Do not place appliance close to radiant heat source.

Do not insert or allow foreign objects to enter any ventilation or exhaust
opening, as this may cause an electric shock, fire or damage to the appliance.

Do not sit on the appliance.

Do not use abrasive cleaning products on this appliance. Clean with a damp
cloth (not wet) rinsed in hot soapy water only. Always remove plug from the
mains supply before cleaning.

Do not operate in areas where petrol, paint or other flammable liquids are used
or stored.

Do not use this appliance in the immediate surrounds of a bath, a shower, or a
swimming pool or other liquids.

General Care and Safety Guide

Summary of Contents for Platinum GPOC4310













Reviews: