Goldair GTRL Series, Operating Instructions Manual

Page: 6 / 10

This appliance MUST be installed in accordance with the relevant wiring rules and
regulations and in particular those regulations which cover installation of appliances
and accessories in damp situations such as bathrooms, showers, laundries and other
areas with fixed water containers. It is to be fitted in accordance with applicable
Australian/New Zealand standards (AS/NZS).
In accordance with New Zealand’s wiring regulations this appliance is required to be
connected to a power supply that includes an earth circuit. This appliance cannot be
connected to a two wire (lighting) power circuit.
WARNING
•
In order to avoid a hazard for young children, this appliance must be installed so
that the bottom rail is at least 600 mm above the floor.
•
Special purpose tools are required for the replacement of the power supply cord
and element. Contact an Authorised Service Agent for service.
•
Please note that if mounting your Heated Towel Rail yourself contact your local
hardware professional for advice on the best mounting hardware for your walls,
as this may vary.
NOTE: Attempting to fix into plasterboard or cement sheeting alone is not
recommended. Plasterboard in particular will not hold long term.
WALL PREPARATION
•
Goldair Heated Towel Rails may be fixed to any type of timber stud, steel stud or
masonry (solid or cavity) wall.
•
Walls made from timber or steel require studs at the correct position for all rails. If
the precise position
can’t be determined early in the job, consider sheets of 18mm
construction ply, covering a larger area.
•
This rail has a small footprint against the wall. The wire holes and mounting holes
must be drilled neatly and accurately.
•
For drilling through hard materials such as porcelain tiles, marble, granite etc. an
appropriate drill bit must be used.
•
No responsibility will be taken by Goldair for instances where installers drill
incorrectly.
Installation cont.