Goldair GTRL Series, Operating Instructions Manual

Page: 7 / 10

WALL MOUNTED MODELS: GTRM AND GTRL
•
Choose a suitable position on the wall to mount the Heated Towel Rail. The flex entry can
be either on the left or right hand side but it must be horizontal and at the bottom of the
frame.
•
Fit the leg brackets and straps loosely to the frame, in the positions shown in figure 1.
•
Place the Heated Towel Rail on a flat surface, check that all the leg brackets are sitting
parallel and then tighten the screws, enough to hold the brackets firmly against the
frame, without over tightening.
•
Level up the top rail of the Heated Towel Rail and fasten to the wall with either the
screws provided or with suitable toggle bolts.
•
Fit the screw caps to cover the screw holes in each of the leg brackets.
PRE WIRING
NOTE: Only drill holes when you are 100% sure of your measurements.
A means for disconnection must be incorporated in the fixed wiring in accordance with the
wiring guidelines AS/NZS 3000:2007.
Electrical installation
WALL MOUNTED TOWEL RAILS ARE ONLY TO BE MOUNTED ON HEAT RESISTANT
WALLS THAT COMPLY WITH CURRENT AS/NZS SPECIFICATIONS & BUILDING
REGULATIONS