Press the Power/Mode (c) button and the heater
will cycle through LOW, MED, HIGH and ECO
modes.
In the LOW, MED and HIGH modes the heater
will
continue
to
run
uninterrupted
as
the
thermostat does not work in these modes.
SETTING THE TEMPERATURE ECO MODE
ONLY
Press the MODE button until the
“ECO” symbol is
shown in the display.
Now press the thermostat (a) button and the
temperature digits will blink.
Use the
“+” and “-” button to set your desired
temperature from 10-30 degrees Celsius.
After
the
desired
temperature
is
set
the
temperature digits will stop blinking and the
current room temperature will appear.
When the heater reached the set temperature it
will switch on and off automatically to maintain the
set temperature.
To find your preferred heat setting; Set the
thermostat to the maximum setting. When the
room reaches a comfortable temperature for you,
look at the temperature reading on the heater and
then set the heater to this temperature. The
heater will now cycle on and off to maintain the
set temperature.
NOTE: the temperature is read from a thermostat
in the heater, for a more accurate reading,
position a separate thermometer in another part
of the room.
TURNING HEATER OFF
Press the stand-by button [f] until sleep mode is
selected and the control panel screen goes off.
Press the on/off switch [F] to turn the appliance
off completely.
To disconnect the appliance, remove the plug
from the socket.
Operating Your Oil Column Heater
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
WARNING: Keep all objects at least 1 metre
from the front, sides and rear of the appliance.
WARNING: In order to avoid overheating, do
not cover the heater.
WARNING: Never leave this heater
unattended.
WARNING: Take care in positioning your
heater, using the Timer will mean the heater
will come on automatically. Fire may result if
the
heater
has
been
placed
next
to
combustible material.
CONTROL PANEL
a.
Thermostat button
b.
+: Temperature & hours increase button
c.
Power/Mode button
d.
Timer button
e.
-
: Temperature & hours decrease button
f.
Power/stand-by button
Check that the heat control switch is set to Off
position before plugging the heater into the mains
supply.
Press the On/Off button (f) to turn the heater on.
The heater will emit a beep and the
symbol will
illuminate on the control panel.
The heater is now in standby waiting for a mode
to be selected.
Press the On/Off button (f) again to exit standby
mode and start the heater in low heat mode.
The
symbol will show on the screen.