COPYING A 24-HOUR PROGRAM
If the same 24 hour program is suitable for several days in the week, you can copy the program
into corresponding days
Enter or find the 24-hour program you would like to copy
Press the Copy button (10). The word
“Copy” will be shown. The “day” will flash as well
Press the timer button (11) to display the day onto which you would like to copy the program. The
day will flash
Press the copy button (10) to complete the operation. The word
“Copy” will disappear from the
display and the day will stop flashing. Repeat this operation to copy the program onto another day.
Press the Copy button (10).
TERMINATE THE
WEEK’S PROGRAM
Press the programming button (8) again to terminate the
week’s programs. The control panel will
now show the correct, program type
“UP”, the temperature, corresponding red or green light, and
the program sequence for the present day. The program is now active and running in
“real-time”.
The program information is stored and will be lost when a factory-set program is used.
ALTERING THE USER PROGRAM FOR THE WEEK
Display the UP program type if another program is operating. See above for how to select the
program.
Press the programming button (8) to open the program.
Make the required alterations as explained in the programs section of this manual.
You will need to alter the complete 24-hour program.
ADJUST THE TEMPERATURE OF A RUNNING PROGRAM FOR THE WEEK
The temperature read by the temperature sensor is relative to the position of the heater in the
room. If the actual temperature is higher than the setting, you can compensate for this by adjusting
the temperature setting. For example, if the comfort temperature is set at 24
o
C but the actual room
temperature is 26
o
C, compensate for this by lowering the setting to 22
o
C. Similarly increase the
temperature setting if the actual room temperature is lower than the setting.
Note: do not make these adjustments if the temperature is stable.
Press temperature button (13). The temperature setting and comfort symbol flash. Use the up and
down arrows to adjust the temperature to your desired setting.
Press the temperature button (13) again so that the economy symbol is displayed. Adjust the
economy temperature in the same way.
Terminate by pressing the temperature button again. The heater will revert to the last selected
program.
TEMPERATURE SWITCH
Press the button (13) for more than 3 seconds, the temperature can be switched between
Fahrenheit (F) and Celsius temperature (C).
The default setting is Celsius.
Operating Your Electronic Panel Heater
