SELECTING A PRE-SET PROGRAM
See the description of all programs (on previous page), explaining their content and how they are
used. The program contents cannot be altered.
Press the program selection button (5). The display will now show the day, the program type (which
will flash), the temperature and the program sequence.
Use the up and down buttons to select the desired program.
Press the program selector button (5) again to end the setting. The program type will stop flashing.
The program is now active and will run.
SELECTING THE USER PROGRAM (UP) PROGRAM
Select program type
“
UP
”
as described in section above.
Press the programming the button (8). The day, time (00:00, midnight), the program sequence and
the word
“
Prog
”
are displayed.
If you would like the program to start on a particular day, for example Saturday, press the timer
button (11) until this day is displayed.
PROGRAMMING THE ECONOMY PERIODS
Use the down button (7) to enter the required economy periods.
The timer will advance in steps of one hour.
When the down button (7) is released, the next comfort period unit will flash.
PROGRAMMING THE COMFORT PERIODS
Use the up button (6) to enter the required comfort periods.
The timer will advance in steps of one hour. When the up button (6) is released, the corresponding
comfort period unit in the program sequence will flash
PROGRAMMING A 24-HOUR DAY
Complete the programming for the whole 24-hour day with economy and comfort periods. After
programming the full 24 hours, the timer will display 00:00 (midnight). The unit is now ready for
programming the next 24-hour day. Press the up and down buttons at the same time to start
programming over again
Operating Your Electronic Panel Heater
DEGREES CELSIUS
DEGREES FAHRENHEIT