SUPPORT AND TECHNICAL ADVICE
PO Box 100-707, NSMC, North Shore City,
Auckland, New Zealand
Monday
– Friday 8am-5pm
Phone: 0800 232 633
Website: www.goldair.co.nz
Maintaining your Hair Clipper
JAMMED BLADES
If very heavy cutting has jammed the blades,
the Adjustable Lever can be used to help
remove hair that is wedged between the two
blades. You may need to remove the blades if
you have allowed them to become very heavily
jammed
Clipper blades were oiled and aligned during
production.
If blades are removed for cleaning or
replacement, they must be realigned.
To realign blades, math the upper and bottom
blades tooth by tooth. The end of the top
blade’s teeth should be about 1.2mm back from
the bottom blade.
If blade alignment is incorrect, add a few drops
of oil to the blades, turn Clipper on for a few
seconds, turn off and unplug. Loosen screws
slightly and adjust. Tighten screws after blades
are correctly aligned.
OILING
To keep your Clipper in top condition, it should
be oiled every few cuts. DO NOT use hair oil,
grease, oil mixed with kerosene or any type of
solvent.
POWER SCREW
You can adjust the power of the Clipper using
the Power Screw. It has been adjusted during
production but if your home voltage is low it may
need further adjustment.
To adjust, use a screwdriver or thin coin to turn
Power Screw clockwise until arm strikes coil,
making a noise. Then slowly turn Power Screw
anti-clockwise until the noise stops. This is the
maximum power setting.
POWER SCREW
