FOR SIDES AND BACK OF HEAD
Place longest attachment comb on Clipper.
Hold Clipper gently against hair with
attachment comb teeth pointing up but sitting
flat against the head.
Trim sides of head, starting at bottom and
moving upwards.
Move Clipper slowly and outward, moving
through hair a small amount at a time.
Repeat around whole head.
FOR SHORTER HAIR
Change to a shorter attachment comb or use a
firmer pressure and tilt Clipper closer to head.
FOR TOP OF HEAD
Place attachment comb teeth flat against head
and trim slowly from front to back.
We recommend that you cut longer to start
with, then continue trimming until you reach
your desired hair length.
OUTLINING AROUND EARS
Do not use attachment combs for outlining.
Push lever to close-cut position.
Comb hair into style. Place clipper between
side burns and ear, ensuring corner edge of
blade is on hairline.
Use hair outline as a guide and carefully and
slowly run Clipper around and behind ears.
SHORT CUTS
– CREW CUTS, ETC
Use longest attachment comb first.
Hold Clipper flat against head and cut from
back of neck up and to crown.
Repeat for sides, moving from bottom up.
For front of head, cut hair against its natural
growth direction. Even up sides.
FOR FLAT TOP
Do not use attachment combs. Use flat comb
and cut hair on top of head over the comb.
TAPERING HAIR
To taper hair to neckline, use shorter
attachment comb. Check for uneven spots by
coming hair. Outline sideburns and neckline
(see Outlining instructions earlier).
ADJUSTABLE LEVER
The lever is located near where your thumb sits
on the Clipper side (if you are right handed).
The Lever allows you to gradually change
closeness of cut without removing/replacing
attachment combs.
When the Lever is in the uppermost position,
blades give the closest cut, leaving hair very
short.
Push the Lever down gradually to slowly
increase cutting length.
In bottommost position, the Lever leaves hair
about the same length as the #1 attachment
comb.
The Lever also extends life of blades as a
different cutting edge is used in each setting.
KEEPING BLADES CLEAR
While the Clipper is running, quickly move
Adjustable Lever from topmost to bottommost
position 2-3 times. If you do this each time you
use the Clipper, it will help to keep blade clear
of hair trimmings.
If your Clipper stops cutting and the action
described above does not help, the blades are
probably dulled and will need to be replaced.
.
Operating your Hair Clipper
LEVER IN
UPPERMOST POSITION
LEVER IN
BOTTOMMOST POSITION
