Operating your Convector Heater
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
SAFETY DEVICE
This appliance has two protection devices. The
first device automatically disconnects &
reconnects the appliance at a pre-set
temperature. The second safety device
disconnects the appliance permanently in case of
overheating, by means of a thermal fuse (it is non
resettable).
Do not attempt to dismantle the heater. There are
no user serviceable parts. For service or repair,
contact an authorised electrical service
technician.
WARNING: IN ORDER TO AVOID
OVERHEATING, NEVER COVER THIS HEATER
CLEANING YOUR HEATER
The heater requires regular cleaning to ensure
trouble free operation:
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool
down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of
the heater to remove dust and dirt.
Use a vacuum cleaner to remove dust and fluff
from around the grills.
Never use solutions such as benzene, thinners or
polishing agents.
Ensure the heater is dry before plugging back into
the mains supply.
Do not use this heater with a programmer, timer,
separate remote-control system or any other
device that switches the heater on automatically.
CAUTION: The heater generates heat during use.
Proper precautions must be taken to prevent the
risk of burns, scalds, fires or other damage to
persons
WARNING Keep all objects at least 1 metre
from the front, sides and rear of the appliance.
ASSEMBLY OF THE HEATER
Fit the feet to the bottom of the heater by aligning
the feet holes with the holes on each end at the
base of the heater and securing with the screws
provided. The screw pack to attach the feet to
your heater will be taped to either one of the feet
for your heater, or taped to the plug head.
HEAT CONTROL SWITCH
The control switch positions are:
0
Off
I
Low Heat
II
Medium Heat (Turn Low Heat Off first)
III High Heat (Low and Medium together)
Check that the Heat Control Switch is set to Off
position before plugging the heater into the mains
supply. For greater economy, use the High Heat
setting initially and then switch to the Low Heat
setting.
FAN FUNCTION
In addition to the three heat settings there is a fan
with a separate On/Off switch located on the
control panel. The fan function is for distributing
heat into the room at a faster rate.
THERMOSTAT
Turn the thermostat knob clockwise until you
reach
the
maximum
temperature
on
the
graduated scale.
When the desired room
temperature is reached, slowly turn the knob anti-
clockwise until the heater turns off (you will hear a
click). The heater will now cycle on and off to
maintain the set temperature.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase.
Goldair
– New Zealand
Monday
– Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair
– Australia
Monday
– Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
SUPPORT AND TECHNICAL ADVICE
