Operating your Convector Heater
TIMER
The heater will always be ON when the slide switch is in the
“I”
position.
The heater will always be OFF when the slide switch is in the
“O”
position.
To set the Timer; set the slide switch to the Timer position.
(This function can only be used once a heat level has been selected.
You must set the time prior to programming the Timer. To do this; turn the outer dial of the
timer in a clockwise direction until the time of the day (24-hour clock) corresponds with the
triangular marking. Example if it is 2pm (1400 hours) then set the triangular mark in line with 14.
One complete turn of the dial corresponds to 24 hours.
There are 96
‘riders’,
positioned around the dial, each rider represents 15 minutes.
Where all the
‘riders’
are pushed to the outside of the timer the heater will be ON continuously.
To set a specific time for example:
If you want the heater to be on from 6pm to 10pm, then set all the riders from 18 to 22 (1800
hours to 2200 hours) to the outside of the rim and all other riders to the inside of the timer. The
unit will then turn on automatically at 6pm and off again at 10pm.
Mode switch positions
OFF
TIMER ON
OVERRIDE
Indicates actual time
Riders pushed to the
outside rim to turn ON
Summary of Contents for GCV100
Page 1: ...Operating Instructions 2000W Convector Heater Model GCV100...
Page 11: ......