Operating your Fan
ECO:
Eco mode enables the unit to adjust wind speed
automatically based on a temperature sensor that
detects the ambient room temperature.
The unit is pre-programmed to read 27
℃
initially,
this cannot be adjusted.
To operate this function press the ECO button.
The display panel will indicate the working setting
of unit by illuminating the ECO backlight.
When the sensor detects an ambient temperature
lower than 25
℃
the Fan will operate in Low wind
speed.
When the sensor detects an ambient temperature
of 25
℃
- 29
℃
the Fan will operate in Medium wind
speed.
When the sensor detects an ambient temperature
higher than 29
℃
the Fan will operate in High wind
speed.
TIMER:
The Timer function allows the Fan to operate
continuously from 1 - 8 hours before automatically
turning Off. The Timer can be operated in any
mode.
Press the TIMER Button on the control panel (or
remote) once and the Fan will display 1 hours.
By pressing the TIME Button again you can adjust
the desired length of time in increments.
The corresponding length of time will illuminate on
the control panel displaying your selected time.
For example: If the Timer is programmed to
operate for 3 hours, the 2 hour and 1 hour light will
be illuminated.
When the selected time has been reached, a beep
signal will be heard and the unit will switch off
.
To stop the Timer function, press TIME button until
time indicators are OFF.
SWING
:
When unit is powered on, press the SWING button
to oscillate the air guide Louvre. Press again to fix
a stationary angle. The display panel will indicate
the working setting of unit by illuminating the
corresponding Swing backlight.
CARE AND CLEANING
The Fan requires regular cleaning to ensure trouble
free operation:
Unplug the Fan from the mains supply before
cleaning.
Ensure that the Fan blade has been allowed to
stop down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of
the Fan to remove dust and dirt.
Use a vacuum cleaner to remove dust and fluff
from around the grills.
Never use solutions such as benzene, thinners or
polishing agents.
Ensure the Fan is dry before plugging back into the
mains supply.
Do not attempt to dismantle the Fan. There are no
user serviceable parts. For service or repair,
contact an authorised electrical service technician.
Goldair
– New Zealand
Monday
– Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair
– Australia
Monday
– Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
SUPPORT AND TECHNICAL ADVICE
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase. (Refer to back of booklet).
