Goldair GCT325, Operating Instructions Manual

Page: 8 / 12

SUPPORT AND TECHNICAL ADVICE
Goldair – New Zealand
Monday – Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
info@cdb.co.nz
Goldair – Australia
Monday – Friday 8am-5pm
Phone +61 (0)3 9365 5100
Phone 1300 465 324
info@cdbgoldair.com.au
Operating Your Heater
TECHNICAL SPECIFICATION
Model No: GCT325
Supply: 220-240VAC 50Hz
Wattage: 2000W
SAFETY DEVICES
This appliance has two protection devices:
•
Tilt Switch - this will automatically turn the appliance off if the appliance is not in
the correct operating position.
•
Resettable Thermal Link - this will automatically disconnect the power to the
appliance at a pre-set overheat temperature. After cooling down it will reset and
power on again. If this occurs, investigate what is causing the appliance to
overheat.
CAUTION:
The appliance generates heat during use. Precautions must be
taken to prevent the risk of burns, scalds, fires or other damage to persons.
CARE AND CLEANING
The heater requires regular cleaning to ensure trouble free operation:
•
Unplug the heater from the mains supply before cleaning.
•
Ensure that the heater has been allowed to cool down completely before cleaning.
•
The common cause of overheating is deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly by unplugging the appliance and
vacuum cleaning the air vents and grills.
•
Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and
dirt.
•
Never use solutions such as petrol, thinners or polishing agents.
•
Ensure the heater is dry before plugging back into the mains supply.
•
Do not attempt to dismantle the heater.
•
There are no user serviceable parts. For service or repair, contact an authorised
electrical service technician.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase.