WARNING Keep all objects at least 1 metre
from the front, sides and rear of the appliance.
HEAT CONTROL SWITCH
The control switch positions are:
0 = OFF
= Fan
I = Low Heat (750W)
II = High Heat (1500W)
Check that the heat control switch is set to the Off
position before plugging the heater into the mains
supply. For greater economy, use the High Heat
setting initially and then switch to the Low Heat
setting.
For the Low (I) and High (II) heat settings the fan
speed remains the same; only the heating block
changes to create the greater/lesser heat output.
THERMOSTAT
Turn the thermostat knob clockwise until you reach
the maximum temperature on the graduated scale.
When the desired room temperature is reached,
slowly turn the knob anti-clockwise until the heater
turns off (you will hear a click). The heater will now
cycle on and off to maintain the set temperature.
SAFETY DEVICE
This appliance has three protection devices:
The
first
device
will
automatically
turn
the
appliance off if the appliance is not in the
appropriate operating position.
The second device automatically disconnects &
reconnects the appliance at a pre-set temperature.
The third device disconnects the appliance in case
of
overheating.
In
the
case
of
accidental
overheating (eg. obstruction of air intake and outlet
grills, motor turning slowly or not at all), reset by
disconnecting the plug from the power for a few
minutes. Remove the cause of overheating then
plug the appliance in again.
Operating your Ceramic Heater
Always choose a safe location for the heater, keeping in mind the safety precautions
outlined. Ensure all packaging has been removed from the unit before use. This appliance
requires no installation, it should be used solely as a portable appliance.
IMPORTANT! NEVER COVER THIS HEATER!
CARE AND CLEANING
The heater requires regular cleaning to ensure
trouble free operation:
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool
down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of
the heater to remove dust and dirt.
Use a vacuum cleaner to remove dust and fluff
from around the grills.
Never use solutions such as benzene, thinners or
polishing agents.
Ensure the heater is dry before plugging back into
the mains supply.
Do not attempt to dismantle the Ceramic Heater.
There are no user serviceable parts. For service or
repair, contact an authorised electrical service
technician.
CAUTION
The Ceramic Heater generates heat during use.
Proper precautions must be taken to prevent the
risk of burns, scalds, fires or other damage to
persons.
Do not use this heater with a programmer, timer,
separate remote-control system or any other
device that switches the heater on automatically.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase.
Goldair
– New Zealand
Monday
– Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair
– Australia
Monday
– Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
SUPPORT AND TECHNICAL ADVICE
