Goldair
– New Zealand
Monday
– Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair
– Australia
Monday
– Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
SUPPORT AND TECHNICAL ADVICE
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase. (Refer to back of booklet).
Cleaning
To avoid risk of electric shock, before
cleaning, you MUST ALWAYS switch off
and unplug the Fan before cleaning.
Use only a soft, damp cloth to gently wipe
the Fan and dry well.
DO NOT immerse the Fan in water and
never allow water to enter the motor
housing.
DO NOT use harsh chemicals to clean the
Fan.
Operating your Fan
Fan control switch
The control switch positions are:
•
0 = OFF
•
1 = Low Speed
Check that the Fan control switch is set to
the off position before plugging into the
mains supply.
Place the Fan on a dry, level and sturdy
surface.
Plug the power cord into the socket,
making sure the speed control is at OFF
position.
To operate the fan turn speed control dial
clockwise until desired wind speed is
achieved.
Adjust tilt by turning neck piece assembly
(8) and tilting body to the desired wind
direction (i.e. either upward or downward).
To activate the oscillation function, push
down the oscillation pin on the top of the
motor. The fan will then oscillate until the
pin is pulled back up.
•
2 = Medium Speed
•
3 = High Speed
