1.
Remove the Milk Frother from the base to
pour in milk. Insert EITHER HEATING or
FROTHING whisk.
2.
Pour milk into the Milk Frother to the
desired level. Use whole milk (fat content
>3%) for best results. Note the
unit’s
capacity range is 80-115ml for frothing
/foaming and 80-240ml for heating). Press
the lid on and place the Milk Frother back
on the base unit.
3.
Connect the plug into a power outlet, turn
on at power outlet.
4.
To FROTH cold milk, press the BOTTOM
button. The button will illuminate in. When
the cycle is complete (about 100 seconds),
the light will flash for about 30 seconds.
5.
To HEAT and FROTH milk, press the TOP
button. The button will illuminate. When the
cycle is complete (about 60 seconds), the
light will flash for about 30 seconds.
6.
Turn unit off at wall. Remove unit from
base. Carefully remove lid and pour milk
into your drink.
7.
Allow 2-3 minutes between uses to avoid
overheating and to allow thermostat to
reset.
8.
If you bump or press a button during
operation, the unit will stop. Simply press
the button again to restart.
WARNING: DO NOT REMOVE THE LID
WHILE THE MILK IS HEATING/FROTHING
USE ONLY THE STAND PROVIDED WITH
THIS APPLIANCE
CAUTION: DO NOT OPERATE THE MILK
FROTHER ON AN INCLINED PLANE
DO NOT MOVE THE MILKF FROTHER WHILE
IT IS SWITCHED ON
CAUTION:
ENSURE
THAT
THE
MILK
FROTHER IS SWITCHED OFF BEFORE
REMOVING IT FROM ITS STAND
Operating your Milk Frother
Care and cleaning
1.
Do not attempt to dismantle the Milk
Frother or power base. There are no user
serviceable parts. For service or repair,
contact an authorised electrician.
2.
Always unplug from the plug socket and
allow to cool down before cleaning.
3.
Remove the heating and foaming/frothing
whisks before cleaning.
4.
TO CLEAN INSIDE THE MAIN UNIT
–
wipe inside walls with a soft cloth and
warm soapy water. Dry with a soft cloth.
Use a soft brush to clean around and
under the motor shaft.
5.
TO CLEAN OUTSIDE OF MAIN UNIT
–
use a sponge or soft cloth to wipe clean.
DO NOT use abrasive or alkaline cleaning
agents. To avoid scratches, DO NOT use
hard nylon or metal brushes or cleaning
pads.
6.
TO CLEAN THE LID
– wash with warm
soapy water and a soft cloth. Dry with a
soft cloth.
7.
TO
CLEAN
THE
HEATING
AND
FOAMING/FROTHING WHISKS
– remove
from unit. Wash in warm water. Dry and
store in safe place. Do not place in
dishwasher.
Goldair
– New Zealand
Monday
– Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair
– Australia
Monday
– Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
SUPPORT AND TECHNICAL ADVICE
