SET-UP INSTRUCTION
6
FIRST OPERATION
1.
Please remove carefully all the protecting foam and check
the items listed are all supplied.
2
.
Place the turntable on a levelled surface, such as a wall
shelf immune to footfall, then level the turntable.
3.
Plug the pre-installed cable into the amplifier phono
input.
4.
Install the counterweight into the rear arm wand of the
arm selecting the correct cartridge tracking weight with the
help of a precision scale (not supplied).
5.
Install the turntable belt surrounding the hourglass motor
pulley and the platter outer perimeter.
6.
Plug the Power Adapter cable to the 12V Turntable.
Speed Control, then plug the AC adapter into the wall socket.
Connect the mini-XLR plug of the cable coming from the
motor of the turntable to the TSC.
POSITIONING THE VALORE 425 PLUS
Your Valore 425 Plus turntable has been designed for Hi-Fi
systems.
It must be protected from direct sun and humidity.
Do not place it near heating sources, electrical and electronic
motors, mobile phones etc.
The levelling and positioning on a solid shelf, as explained in
the previous chapter, is fundamental to ensure the best audio
performances.
OPERATING THE 33
⅓
rpm
& 45
rpm
CONTROL
The turntable is fully controlled by an electronic power
supply.
TURNTABLE SPEED CONTROL ADJUSTMENTS
• Inner button starts and stops the 33
⅓
rpm
speed.
Once the 33
⅓
rpm
is playing its red LED light turns on.
• Outer button starts and stops the 45
rpm
speed.
Once the 45
rpm
is playing its red LED light will be on.
The turntable also features a fine speed adjustment “Pitch
Control” function to allow a very fine and precise speed
calibration.
PITCH CONTROL MODE
To enter the PITCH CONTROL MODE press and hold for 4
seconds both 33
⅓
rpm and 45rpm buttons while the
turntable is spinning.
When the red LED light shuts down, the unit is ready for the
fine speed adjustment.
• PITCH –
press repeatedly the 33
⅓
rpm
button until the correct speed is
reached.
The LED light flashes every time the button is pressed.
• PITCH +
press repeatedly the 45
rpm
button until the correct speed is
reached.
The LED light flashes every time the button is pressed.
See pag.12 for images.
To switch off of the PITCH CONTROL MODE press and hold for 4
seconds both the 33
⅓
rpm
and the 45
rpm
buttons until the LED
light is on and steady again.
