Gold Metal 3015A, Instruction Manual

Page: 3 / 19

Model 3015A
3
Installation Instructions
Inspection of Shipment:
Unpack all cartons and check thoroughly for any damage that may have occurred during
transit. Damage claims should be filed immediately with the transportation company. Gold
Medal Products is not responsible for damage that occurs in transit.
Setup:
Your new Warmer is completely assembled and tested at the factory.
Remove all packing material and tape before starting operation.
Electrical Requirements:
The following power supply must be provided:
120 Volt, 60 Cycle, single phase
Your electrician must furnish sufficient power for proper machine operation. We recommend
this warmer be on a dedicated and protected circuit. Failure to wire properly will void the
warranty and may result in damage to the machine.
It is Gold Medal Products Company’s recommendation that this machine be plugged directly
into a wall outlet. The use of extension cords is not recommended due to safety concerns,
and may cause sacrificed and/or reduced performance.
Before You Plug In Machine:
1. Make sure the wall outlet can accept the grounded plugs (where applicable) on the power
supply cord.
2. The wall outlet must have the proper polarity. If in doubt, have a competent electrician
inspect the outlet and correct if necessary.
3. DO NOT use a grounded to un-grounded receptacle adapter.