Sterno Hot Dog Cart
Model No. 8080S
Page 6
gmpopcorn.com
Setup
This unit has been tested at the factory.
1.
Remove all packing material and tape before starting operation.
2.
After unpacking the unit, rotate the display handles from the shipping position to the
display (UP) position. Remove the two thumb screws holding each handle. Rotate the
handle into the display position and refasten with the thumb screws.
Note:
The Display Handles are for display purposes only. Transport handles are
provided for carrying the unit (see image below).
3.
Insert the Pans and Lids for use (some pan configurations use a steam pan crossbar).
4.
Insert Umbrella (without a handle) into the Extension Tube end with the bushing.
5.
Slide the extension tube with the umbrella down into the Umbrella Mount. (The
Umbrella Mount is factory installed using two Thumb Screws, ensure Thumb Screws
are fully tightened for use.)
To remove the Umbrella and Extension Tube, slide the Extension Tube out of the
Umbrella Mount (the Umbrella Mount can stay attached to the unit for future use).
Extension
Tube
Umbrella
(WITHOUT handle)
Bushing
Attach Umbrella
Mount Extension
Tube to Unit
Extension
Tube
Umbrella Mount
(mounted to unit
with thumb screws)
Thumb Screws
(fully insert thumb
screws to secure)
Transport Handles
(one handle on each
end of unit)
Display Handles
(shown in UP position)
Display Handle
(shown in shipping
position)
