Pop-O-Gold
http://www.gmpopcorn.com
Page 10
POPPING SWEET CORN (IF EQUIPPED)*
1.
Turn all switches ON; the Salt-Sweet Switch should be on Sweet mode (if equipped, the Flexi-
Pop Switch should be set on 32 oz.).
Note: When popping with coconut oil, be sure the oil is liquid. As a check, dispense oil into a
measuring cup first (should be between 8 to 10.5 oz.), then use that oil for the first
popping cycle.
2.
When the kettle is ready (about 5-8 minutes), the Yellow Light and Audible Signal (if enabled)
will turn ON.
3.
Lift the kettle lid and pour in 32 oz. of corn (use the supplied corn cup).
4.
Press the “Red” Oil Dispense PB Switch to add oil. The proper amount of oil is pumped into the
kettle. The Light and Signal will turn OFF.
5.
Add 16 oz. (473ml) of Glaze Pop or Sugar. (When using sugar, we recommend the use of
Compound “S” to help keep the kettle clean.) Close lid.
6.
When the corn has finished popping the Light and Signal will turn ON, then gently dump the
popcorn.
Note: The signal “To Dump” was factory set based on our popcorn and oil. If the signal occurs
before or after the popping has stopped, the signal timing must be adjusted. Have a
qualified service person adjust the signal to dump (reference the Electronic
Temperature Control section).
7.
On the final kettle of corn, turn the Kettle Heat Switch OFF just as the lids are forced open by
the popping corn. This procedure saves electricity, since the kettle has plenty of heat, and helps
eliminate smoke/odor from any oil residue that remains after popping has stopped.
Note: When the Kettle Heat Switch is OFF, the machine will not beep on the last batch.
8.
When finished popping, make sure KETTLE HEAT and KETTLE MOTOR switches are turned
OFF.
NEVER LEAVE THE HEAT ON WHEN YOU ARE NOT POPPING CORN!
9.
Clean the kettle when finished popping Glaze Pop or sugar corn, and prior to popping standard
popcorn.
*Note: If the machine is equipped with Salt-Sweet and Flexi-Pop options, sweet popcorn may be
popped in flexi mode. Follow the instructions for popping sweet corn and set the Flexi-Pop
Switch to 18 oz. The amounts of corn and oil will be roughly half of the standard amount
listed. Pop a few test batches and adjust as needed until you have achieved the best results.
