DT Pump Head User’s Guide
5
head to the drive.
4.3
Tube Loading
1) Be sure the pump drive is turned off.
2) Remove the cartridge from pump head.
3) For DT10 only: Tubing for DT10 need two stops installed to fix it on
the pup head. Adjust the desired distance between the two stops on
the tubing to around 105mm for optimum performance, as shown
105mm
Figure 3. Stops for DT10 Pump Head
4) Load the tubing into the slot of the cartridge on each side Make sure
the tubing is not twisted.
Figure 4. Load Tubing
5) Hook the left side of the cartridge on the rod of the pump head, and
press the cartridge down to hook the right side to the right rod of the
pump head.
