GOGpaintball.com
The internal gas lines and electronic components of the eXTCy
TM
are well protected inside its body – however they are delicate and may be damaged by improper handling
or re-installation. For this reason it is highly recommended that full disassembly of the eXTCy
TM
be performed by an airsmith with GOG Paintball
TM
factory training, and then
only when necessary to fix a problem or install an upgrade. Removal of internal hoses from their barbed fittings will stretch them to the point that they cannot be re-used
without causing leaks. In other words, if it ain’t broke, don’t fix it.
Occasionally a more thorough disassembly of the eXTCy
TM
receiver is necessary to remove paint or debris that has worked between the breech and body shell, replace a
damaged component or install an upgrade. These tasks require removal of the grip frame and or disassembly of the body.
Unload and degas the eXTCy
TM
, remove the barrel, rubber grip and battery, following the instructions in this manual. Similarly, field strip the bolt/valve system.
Using a 1/8-inch allen wrench, remove the breech screw from the front of the breech. Next remove the two grip frame screws securing the grip frame to the body. Carefully
slightly separate the grip frame from the receiver. Be aware that the clear power button can fall out of its position in the side of the grip frame. Be careful not to drop or lose
it. The body will still be connected to the grip frame by the hose running between the front of the grip frame and the solenoid valve on the circuit board.
Tilt the body slightly away from the grip frame and carefully use a 1/8-inch allen wrench to unscrew the barbed banjo fitting which connects the gas supply hose to the grip
frame. Alternatively, the hose may be pulled off of the barb in the grip frame - doing so will require the hose to be replaced however, as its end will have been stretched by
the barbed fitting and will no longer seal reliably.
Completely separate the body from the grip frame. Watch to make sure the battery clip does not snag in the grip frame as the two parts are separated.
Reassembly of the grip frame to the body is done in the reverse order, taking care not to allow the battery wires to or hoses to become pinched or entrapped while joining
the body to the grip frame. Use the long end of the allen wrench when reinstalling the banjo fittings and grip frame screws, to avoid over-tightneing.
Over-tightening or cross threading screws or fittings may result in permanent, nonrepairable damage to the breech.
FIG. 15
GRIP FRAME REMOVAL
FIG.14
BREECH SCREW REMOVAL
ADVANCED MAINTENANCE
NOTE:
Unload and degas the eXTCy
TM
before
any cleaning or maintenance work.
17