GOGpaintball.com
At the end of each day’s use and before performing maintenance work on your eXTCy
TM
, it will
need to be de-gassed, and all paintballs must be removed.
In an area where it is safe to shoot (such as the chronograph area at a paintball field) and while
wearing paintball goggles, remove the hopper from the eXTCy
TM
. By turning the eXTCy
TM
upside
down, you can empty any extra paintballs from the feedneck into your hand. Turn the eXTCy
TM
on.
Dry-fire 2 or 3 shots in a safe direction to ensure that no paintballs remain in the eXTCy
TM
. In order
to dry-fire the marker, the Vision
TM
anti-chop system must be turned off (see Vision
TM
operation) or
set to one of its delayed modes (see Electronic Adjustment).
Turn off the HPA system if it is equipped with its own on/off control, or turn off the HPA system or
CO
2
tank by turning the bottom-line ASA control knob counter-clockwise. Dry fire the
eXTCy
TM
in
a safe direction until all of the gas pressure inside has been released. At this point the only sound
you should hear when you pull the trigger is the click of the solenoid valve. Often this sound will
be too quiet to hear. Turn off the eXTCy
TM
.
If using a CO
2
tank or screw in HPA system, unscrew it from the bottom-line ASA.
EVEN WITH NO CO
2
OR COMPRESSED
AIR
SYSTEM
ATTACHED,
THE
EXTCY
TM
MAY STILL HAVE ENOUGH
GAS PRESSURE STORED IN THE
REGULATOR AND FIRE CHAMBER TO
FIRE 2 OR MORE SHOTS. YOU MUST
DE-GAS YOUR EXTCY
TM
BEFORE
PERFORMING ANY MAINTENANCE
PROCEDURES.
UNLOADING/DE-GASSING
PLEASE READ CAREFULLY
ALWAYS WATCH COMPRESSED GAS
CYLINDERS (CO
2
OR HPA) TO MAKE
SURE THAT THE CYLINDER AND VALVE
ARE UNSCREWING FROM THE ASA,
AND THAT THE CYLINDER IS NOT
UNSCREWING FROM ITS VALVE. IF THE
CYLINDER DOES BEGIN TO SEPARATE
FROM ITS VALVE, STOP IMMEDIATELY,
AND
SEEK
PROFESSIONAL
ASSISTANCE.
14