Goepel basicCAN 61 PLUS, User Manual

Page: 14 / 37

Hardware
3-4 basicCAN 61 PLUS – User Manual
3.4 Rear View
• ‚ ƒ „
•
Ethernet
Ethernet connection
‚
USB USB 2.0 connection
ƒ
ext. Power basicCAN
External supply input for
basicCAN 61 PLUS
„
ext. Power Front
External supply input for Test object
(red - plus, black - minus)
3.5 Function
The LEDs arranged at the front panel (see Figure 3-2) indicate
several states of your basicCAN 61 PLUS :
Status 1, 2, 3, 4 Status LEDs: These LEDs indicate the current
operation state of the basicCAN 61 PLUS
The operation states are explained in the following table:
LED 1 LED 2 LED 3 LED 4 Remarks
Permanently ON Controller does not run (error!)
Alternately blinking Bootloader software runs
blinking Firmware runs
ON
(shortly)
State during execution of a
Firmware command on the
OnBoard interfaces 1..4
ON Ethernet connection established
DO 1..4 Digital OUT: These LEDs indicate the state
of the digital outputs 1..4 ( Digital connector)
Power LEDs 1..3: The two upper LEDs indicate that the
KL30 test object supply is connected,
while the lower LED indicates that the
KL15 test object supply is switched ON
Figure 3-3:
Rear view
3.5.1 Status
LEDs