Goelst G-Motion, Manual

Page: 30 / 44

26
4 Programming
English
7. The LED on the motor unit slowly flashes white again for 15 seconds: using the
OPEN
or
CLOSE
buttons another MENU 2 feature can be selected.
8. Otherwise, wait for 15 seconds or shortly press the
OPEN
+
CLOSE
buttons to quit
programming.
The LED on the motor unit switches off, the system is ready to use.
To quit programming at any time, repeatedly press the
OPEN + CLOSE
buttons or wait for 15s.
Changes made at 5 will only be saved if confirmed by pressing the OPEN
+
CLOSE buttons
.
2.4.2 Touch and Stop
motor LED colour light blue:
Touch and Stop self-calibrates during the first 3 completed runs of the system, after reset-
ting (new) end postitions, changes in speed settings or after reactivating the feature.
Touch and Stop feacture has 2 settings: On or Off.
In some cases the Touch and Stop feature might not function as expected: this is the case
when curtain fabric causes friction with floor, walls or the curtain track itself.
Or in case of any other source of resistance, causing the Touch and Stop function to be
activated.
Touch and Stop auto-calibrates at regular intervals, but in cases it can be advised to start
self calibration by switching this feature off and on again. If unexpected stopping of the
system remains, it is advised to switch off this feature.
Note: After 15s. without input, the motor unit quits programming mode.
Please read the steps of this feature first before starting.
1. Press and hold the
OPEN
+
CLOSE
buttons until the LED on the motor unit slowly flash-
es white (after ~8s.) (First the LED will turn white continuously, keep the button(s)
pressed)
2. Repeatedly press
OPEN
or
CLOSE
until the LED on the motor unit is light blue.
3. Shortly press the
OPEN
+
CLOSE
buttons to enter the feature menu,
4. The LED on the motor unit now flashes light blue at the current setting:
5. Cycle through the options below using
OPEN or CLOSE:
1x flash = On (Default)
2x flash = Off
6. Confirm and store setting by shortly pressing
OPEN
+
CLOSE
buttons.
7. The LED on the motor unit slowly flashes white again for 15 seconds: using the
OPEN
or
CLOSE
buttons another MENU 2 feature can be selected.
8. Otherwise, wait for 15 seconds or shortly press the
OPEN
+
CLOSE
buttons to quit
programming.
The LED on the motor unit switches off, the system is ready to use.
To quit programming at any time, repeatedly press the OPEN
+
CLOSE buttons or wait for 15s.
Changes made at 5 will only be saved if confirmed by pressing the
OPEN + CLOSE
buttons.