Modeling Lamp Settings
1. Multi-group displays in the TTL mode
1.1
Press the group button to choose the group, turn the select dial, and the FEC
value will change from -3 to ~3 in 0.3 stop increments. Press the <
SET
> button
to confirm the setting.
1.2
Press <
ALL
> button to choose all groups’ FEC value, turn the select dial, and all
groups’ FEC value will change from -3 to ~3 in 0.3 stop increments. Press
<
ALL
> button again to confirm the setting.
2. One-group displays in the TTL mode
Turn the select dial and the group’s power output value will change from -3 to ~3 in
0.3 stop increments.
1.
When displaying multiple groups, press the <
MOD
>
button to control the ON/OFF of the modeling lamp.
2.
Press the group button to choose the group when
displaying multiple groups or when displaying one-group,
press the <
MOD
> button to control the ON/OFF of the
modeling lamp (note: The models that can use one-
group to ON/OFF the modeling lamp are as follows:
GSII, SKII, QSII, QDII, DEII, DPII series, etc. The
outdoor flash AD200 and AD600 can use this function
after upgrade. The new arrivals with modeling lamps can
also use this function.).
Flash Exposure Compensation Settings
1.
In the multi flash (TTL and M icon are not displayed).
2.
The three lines are separately displayed as power output
value, Times(flash times) and Hz (flash frequency).
3.
Turn the Select Dial to change the power output value
from Min. to 1/4 in integer stops.
4.
Short press the Times button can change flash times.
Turn the select dial to change the setting value.
5.
Short press the THz button can change flash frequency.
Turn the select dial to change the setting value.
Multi Flash Settings (Output Value, Times and Frequency)
Setting the Flash Trigger
Setting the Flash Trigger
CH1
A
B
C
D
E
--
ON
1
/64
--
--
--
CH/Zm Times
Hz
MOD
3 Times
1 Hz
MULTI
6.
Until all the amounts are set. Or during any value setting, short press the <
MODE
>
button to exit the setting status. No values will blink.
7.
In the multi flash setting submenu, short press the <
MODE
> button to return to main
menu when no values are blinking.
Note:
As flash times are restricted by flash output value and flash frequency, the flash
times cannot surpass the upper value that permitted by the system.
The times that transported to the receiver end are a real flash time, which is also
related to the camera’s shutter setting.
CH1
CH/Zm
SYNC
MOD
A
B
C
D
E
ALL
--
M
1
/128
--
--
--
- 38 -
- 37 -
