CH
OFF
CH
OFF
CH
OFF
The flash unit has built-in 2.4G wireless transmission, which can be used
together with X1,
X2, XPro and XT16
or FT-16 flash trigger.
Press the < > Button and the <S1/S2> Button can turn on the built-in wireless
transmission and the < > is displayed. If there are other wireless flash systems
nearby, you can change the channel IDs to prevent signal interference. The
channel IDs of the master unit and the slave unit(s) must be set to the same.
The device is equipped with memory function for the panel setting. It will help
remember the panel setting 3 seconds after you set it. When starting up the flash
next time, the panel setting will be the same as that before powering it off.
Memory Function
Wireless Control Function
Long press the <
GR/CH
>
1
Button for 2 seconds until
the channel IDs is blinking.
Turn the Select Dial to choose
2
the channel from
1
to
32
.
Press the <
SET
> Button to
3
confirm.
Short press the <
GR/CH
>
1
Button for 2 seconds until
the group IDs is blinking.
Turn the Select Dial to choose
2
the group from
0
to
F
.
Press the <
SET
> Button to
3
confirm.
CH
S
OFF
CH
S
OFF
Setting the Communication Channel
To control the flash wirelessly, you need a FT-16 remote control set (on-
camera and on-flash). Insert its receive end into the Wireless Control
Port on the flash and insert the transmit end into the
camera hot shoe. Settings made on the hotshoe-
mounted transmit and receive ends will be wirelessly
communicated to the flash. Then you can press the
camera shutter release button to trigger the flash. You
can also hold the transmit end at hand to control your
off-camera flash.
The flash unit is built in with a Wireless Control Port so that you can
wirelessly adjust the power level of the flash and the flash triggering.
For full instructions on the use of FT series remote control, see its user manual.
2. Please make sure that whether the flash has finished its recycle or caught up
with the continuous shooting speed or not(the flash ready indicator is
lighten) and the flash is not under the state of over-heat protection or other
abnormal situation.
→
To adjust the channel CH setting on the flash trigger (add 10+ channels) and
use the channel which is not disturbed. Or turn off the other 2.4G equipment in
working.
→
Please turn on the “close distance wireless mode” on the flash trigger (
＜
0.5m):
→
Please replace the battery(the flash trigger is recommended to use 1.5V
disposable alkaline battery).
4. Whether the flash trigger and the receiver end equipment are in the low
battery states or not
X1 and X2 series:
press the test button and hold on, then turning it on until the
flash ready indicator blinks for 2 times.
1. Disturbed by the 2.4G signal in outer environment (e.g. wireless base station,
2.4G wifi router, Bluetooth, etc.)
3. Whether the distance between the flash trigger and the flash is too close or
not
XPro series:
Set the C.Fn-DIST to 0-30m.
→
Please downgrade the flash power output. If the flash is in TTL mode, please try
to change it to M mode(a preflash is needed in TTL mode).
The Reason & Solution of Not Triggering in Godox 2.4G Wireless
- 17 -
- 18 -
Setting the Communication Group
CH
OFF
