Godin 362105, Instructions Of Installation

Page: 5 / 13

5 | P a g e
INSTRUCTIONS FOR THE INSTALLER
Note: before the installation is carried out, ensure that the chimney is in good condition and will provide
adequate draught. It is imperative that the diameter of the flue piping is not altered and is installed with
180mm flue piping.

The installation must be in compliance with local authorities and carried out by a competent
professional.

The factory fits the spigot at the rear of the appliance. It can be connected directly to a chimney by
using a horizontal pipe. The chimney connection can also be taken off the top of the unit; this can
be done by interchanging the covering plate and the spigot.
Important:

If the floor is made of flammable materials it is necessary to protect it with some form of
installation. This must be a non-combustible material and should provide 40cm clearance in
front of the stove.

Preferably use enameled flue pipes, as their resistance to corrosion is remarkable.

The flue pipes get hot; make sure they are away from any combustible materials.

The walls on the left and the right hand side need to be a minimum of 30cm from the unit, and
made of non flammable materials.

The rear wall must not be of flammable materials. If the rear wall is of a flammable material, it
must be protected sufficiently and effectively.
GENERAL INFORMATION

When operating the unit, do not open the door by hand, use the operating tool supplied.

The units are designed to be burnt with the door in the closed position.

Load the unit from the front door.

The regulation of the combustion is done by the engraved positions situated on the front of the door.
(Position 1 = slow, Position 2 = Moderate operation, Position 3 = Normal to high)

For normal functioning use 3-4 logs set on position 2 or 3.

For slow running, leave the fire until it has burned quite low, and then load with one or two logs and
close the flap. It is always possible to add more logs to prolong the period of the combustion of the
heater.

Do not load higher than 25cm.

The operation of the fireplace depends on the kind of wood and the dryness of the wood.
HOW TO USE THE UNIT

Always follow the instructions.

During the first lighting of your heater use small loads of wood to verify that the unit is functioning
properly.

Never use the unit as an incinerator.

Only use the recommended fuel.