DT2L/DT4L USER MANUAL
APPENDIX
Further Explanation
1. To enable the cutter senor of linerless label, please send command “XSET,LINERLESS,1” to DT4L printer, “XSET,LINERLESS,0”
to disable detection of cutter sensor.
2. In case green LED is blanking and no-label print out, please check to cutter sensor, does any label left right on the sensor.
3. The tear off position of DT4L is about 35mm. In some case, after cut and back-feed more than 30mm to print next page,
it may cause a trifling twist line on label. To avoid this problem, DT4L F/W has been limited it to maximum 30mm as
following description:
The tear off position has been limited to 30mm only. However, the command ^E30 is maximum
distance can be set in this F/W version. So, please set the label high (length) to 35mm at least,
^Q35,0,0 ( 35mm ) or above
As below the label created by GoLabel, it keeps 5mm on top for non-print area. But in reality, the
print-out is shown as next below which has two areas are non-printable - top and bottom.
This area can't be printed
This area can't be printed
This area can't be printed