EN
EN - 83
- extended temperate: ‘this refrigerating appliance is intended to be used at ambient
temperatures ranging from 10 °C to 32 °C (SN)
- temperate: ‘this refrigerating appliance is intended to be used at ambient
temperatures ranging from 16 °C to 32 °C (N)
- subtropical: ‘this refrigerating appliance is intended to be used at ambient
temperatures ranging from 16 °C to 38 °C (ST)
- tropical: ‘this refrigerating appliance is intended to be used at ambient
temperatures ranging from 16 °C to 43 °C (T)
Location
The appliance should be installed well away from sources of heat such as radiators,
boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is positioned below an overhanging
wall unit, the minimum distance between the top of the cabi-net and the wall unit must
be at least 100 mm. Ideally, however, the appliance should not be positioned below
overhanging wall units. Accurate leveling is ensured by one or more adjust-able feet
at the base of the cabinet. This refrigerating appliance is not intended to be used as
a built-in appliance.
WARNING!
It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
Electrical connection
à
Before plugging in, ensure that the voltage and frequency shown on the rating plate
correspond to your domestic power supply. The appliance must be earthed. The power
supply cable plug is provided with a contact for this purpose. If the domestic power
supply socket is not earthed, connect the appliance to a separate earth in compliance
with current regulations, consulting a qualified electrician.
à
The manufacturer declines all responsibility if the above safety precautions are not
observed.This appliance complies with the E.E.C. Directives.
IV. REVERSE DOOR
Tool required:
philips screwdriver, flat bladed screwdriver, hexagonal spanner.
à
Ensure the unit is unplugged and empty.
à
To take the door off, it is necessary to tilt the unit backwards. You should rest the unit
on something solid so that it will not slip during the door reversing process.
à
All parts removed must be saved to do the reinstallation of the door.
à
Do not lay the unit flat as this may damage the coolant system.
à
It’s better that 2 people handle the unit during assemly.
Summary of Contents for RDB 0143 GW8F
Page 26: ...CZ 26 CZ Pozn mky...
Page 120: ...10 12 2020...
