EN
EN - 77
Filter assembly
For best performance and results, the filter assembly must be cleaned. The filter efficiently
removes food particles from the wash water, allowing it to be recirculated during the cycle.
For this reason, it i s a good i dea to remove the l arger food particles trapped in the filter after
each wash cycle by rinsing the semicircular filter and cup under running water. To remove the
filter assembly, pull on the cup handle in the upward direction. The entire filter assembly should
be cleaned once a week.
To clean the coarse filter and the fine fi lter, use a cleaning brush. Then, reassemble the filter
parts as shown in the figures left and reinsert the entire assembly in the dishwasher, positioning
in its seat and pressing downward. The dishwasher must never be used without the filters.
Improper replaceme nt of the filter may reduce the performance level of the appliance
and damage dishes and utensils.
WARNINg!
Never run the dishwasher without the filters in place. When cleaning the filters, don‘t knock on
them. Otherwise, the filters could be contorted and the performance of dishwasher could be
debased.
Cleaning the Doors
-
To clean the edge around the door, you should use only a soft warm, damp rag. To prevent
penetration of water into the door lock and electrical components, do not use a spray cleaner
of any kind.
-
Also, never use abrasive cleaners or scouring pads on the outer surfaces because they will
scratch the finish. Some papers towels can also scratch or leave marks on the surface.
WARNINg!
Never use a spray cleaner to clean the door panel for it could damage the door lock
and electrical components. It is not allowed to use the abrasive agent or some paper
towel becauseof the risk of scratching or leaving spots on the stainless steel surface.
Summary of Contents for DFB 1266 MW8
Page 85: ...Pozn mky Notes...
Page 86: ...Pozn mky Notes...
Page 87: ...Pozn mky Notes...
Page 88: ......
