Gocycle Service Document: G2 Servo 1.0
October 2014 © Karbon Kinetics Limited. All Rights Reserved.
3
E
LECTRICAL
S
YSTEM
B
EST
P
RACTICE
G
UIDELINES
1.
It is not recommended to disconnect, connect, remove or install the battery in environments
above 40°C.
2.
If you discover damage to any of the electrical system components other than light cosmetic,
such as exposed or corroded electrical connections or damaged wiring contact your authorised
Gocycle Service centre immediately and do not attempt to operate the Gocycle.
3.
Do not short circuit the battery terminals.
4.
Power terminals must only be connected or
disconnected when the battery is in ‘Sleep Mode’
(switched off).
5.
Use extreme care when handling the battery to
prevent any physical damage. Immediately contact
your authorised Gocycle Service centre if there is
physical damage.
6.
Do not puncture or subject the battery to strong
impacts.
7.
Do not attempt to disassemble or modify the battery.
8.
Do not expose the battery to excess water or moisture.
9.
Ensure battery terminals are connected securely and
correctly; positive to positive (red-to-red), negative
to negative (black-to-black) before switching on your
Gocycle.
10.
The battery has been designed specifically for use
with the generation-two (G2) Gocycle. Do not use
the battery with any other product.
11.
The battery is intended to remain within the Gocycle
frame at all times and should be removed only by a
Gocycle-approved service centre or with the
assistance and approval of a Gocycle Technical
Support Executive.
12.
Do not expose the battery to fire.
13.
Only use the specified Gocycle G2 charger.
14.
Do not leave the battery unattended whilst charging.
15.
Only use, charge or store the battery in an
environment with ambient temperatures between 0°C and 40°C (32°F and 104°F) and a
humidity of 45% to 85% RH.
16.
If you wish to remove the Gocycle Light Kit, the light harness on Gocycles FN <240000 must
also be removed.
