EN
9
IV PACKAGE CONTENT
Open the package, and take the device out carefully. Check whether the set is complete, and
undamaged. Make sure that the plastic parts are not cracked, and the cable is not damaged.
If any part is missing or damaged, do not use the device, but contact the seller. Keep the
package or dispose in accordance with the local regulations.
Note!
To protect the children, don't leave the parts of the package freely available (plastic
bags, cardboard boxes, foamed polystyrene, etc.). The risk of suffocation!
V PRODUCT DESCRIPTION (Fig. . A)
A – charge inserting
B – charge removal
C – temperature setting (-)
D – temperature setting (+)
E – charge opening
F – power supply socket
G – power supply LED
H – LED display
I – operation LED
J – charge feeding speed adjustment
K – feeder thermal cover
VI EQUIPMENT OPERATION
1. Insert the plug of the power supply unit into the electrical socket. Then, connect the cable
of the power supply unit with the device, the yellow LED is on (G).
2. On the LCD display, the following text will be displayed: "ABS" or "PLA". Choose the
material to be used, with the C or D button.
3. Confirm the selection by pressing the A button. The red LED (I) is on, and the nozzle (K)
starts heating up. After reaching the target temperature, the LED (I) will change its color to
green.
4. When the device is warmed up to its working temperature, insert the charge into the
charging opening E using the A button. If liquid material appears in the nozzle, this means
that the charge is loaded correctly.
5. Using the J button, you can adjust the speed of the charge emerging from the nozzle.
Adjust the speed as necessary.
6. The melting temperature of ABS and PLA charges may vary significantly depending on a
charge's color. This is due to the pigments used in the filaments. The temperature can be
adjusted using the C and D buttons.
