EN
8
I INTRODUCTION
Thank you for choosing our product. We believe that it will be a pleasure to use it.
The device is intended to make objects of plastic - it allows you to draw objects in the air
quickly and easily!
II TECHNICAL SPECIFICATION
Power supply parameters: 100V-240V ~, 50/60Hz, class 2
III SAFETY MANUAL
1.
Read the manual thoroughly before use. Please keep this manual for future reference.
2.
Before connecting the device to the power supply, make sure that the parameters of the
electrical network correspond to the data on the device's rating plate.
3.
The device is to be used inside rooms.
4.
It is not allowed to leave the device without supervision when it is connected to the
power supply network.
5.
This equipment may be used by children at least 8 years old, and by persons with
reduced physical, mental capability, and persons without experience or knowledge of the
equipment, as long as they are supervised while using the equipment. Children should
not play with the equipment. Children without supervision should not clean or perform
maintenance of the equipment.
6.
If the supply cable and/or the power supply are damaged, they must be replaced by the
manufacturer or an authorized service.
7.
The printing nozzle can reach a temperature of even up to 230°C. Do not touch the tip of
the device or the plastic material immediately after it flows out from the nozzle, since
this may result in burns. Avoid contact with the body and with flammable substances.
8.
Do not put any other material into the opening intended for charging the PLA or ABS
insert. This may damage the equipment.
9.
Use only the power supply unit dedicated for the device.
10.
In order to prevent short-circuits and damage in the device, make sure the end of the
power supply unit and the charges are never wet.
11.
Do not use the device in humid environment.
12.
The device should be stored in a dry and safe place.
13.
Do not press the printer control buttons with too much of force. This may cause
mechanical damages to the buttons.
14.
When transferring the device to a third party, this manual must be transferred along with
it. The electronic version of the manual is available at: [email protected]
