EN
10
7. 3D PEN switches into the sleep mode, when there is no activity for more than 2,5 minutes.
To switch the equipment to the operation mode, press the A button.
8. If you want to replace the charge (change the color), press the B button, and then perform
the steps from item 3.
9. Double press the A button to activate continuous operation. Subsequent single pressing
turns continuous operation of the 3D pen off.
10. Every 30 minutes, stop the device's operation for 5 minutes. After two hours of
continuous operation, leave the device for at least 30 minutes.
Note:
Do not use the charges completely! When the end of a charge gets close to the charge
opening, pull out the charge and apply a new one. Otherwise if a new charge is uploaded
before the old is removed, the device's nozzle can be clogged.
Cartridge replacement
1. When inserting a charge into the device, make sure that the end of the filament is cut
straight and not deformed. This will prevent problems at loading the charge.
2. You can also switch the device off without pulling the new charge out. For this purpose,
press the B button for a while to move the material out completely from the nozzle.
Disconnect the power supply.
3. When exchanging a charge while printing, remember that a new charge must be inserted
holding the A button until heated material starts flowing from the nozzle.
4. While printing, the nozzle must be kept clean. It cannot be soiled with a charge, since the
charge heated for a long time in one spot gets sintered and clogs the nozzle.
Charging to:
1.
A different color
. When replacing a charge with another color, press the B button until the
whole material comes out from the device. Then, insert a charge of different color and press
the A button, hold this button until the material in the newly loaded color comes out from
the nozzle. Printing can begin.
2.PLA to ABS.
When replacing a PLA charge with an ABS charge, press the B button until the
whole material comes out from the device. Now disconnect the power supply plug from the
device and plug it again. The device will be RESTARTED. Now with the buttons on the LCD
display, change the charge type to ABS and press the A button. Wait until the LED (I) changes
