Use the Backboard Pads as a Template and mark the hole locations on the backboard frame.
Note: Safety glasses required for Step 25.
Drill 9/64 pilot holes through aluminum trim and into Steel backboard frame as shown in
Detail C
.
DO
NOT
drill through both sides of tube.
Note: Cordless drill recommended for screw installation. Do not over tighten screws causing
screws to strip.
Note: To install screws, it will be easier if you use a cordless drill with 5/16” socket (instead of
Phillips head.)
Secure Backboard pads using screws provided (
#51
) as shown in
Figure 13
.
24.
25.
26.
Figure 12
23.
Adjust unit to lowest position. Use a tape measure to measure
from the top of the rim to the playing surface. Stick Height Decal
(#17) to back of Actuator (#16) with the measured height mark
aligned with bottom of Actuator Sleeve (#15). See Figure 12.
16
17
12
Grease fitting
Detail C
Backboard
Pads (# 48 & 49)
Mounting Screw
(# 51)
51
51
51
48
49
*Rim not
shown for
clarity.
Figure 13
