7
8.
Attach Upper Arm (#6) to Pole (#2), as shown in
Figure 7,
using a bolt (#7), two flat washers (#3), four plastic washers
(#5) and hex nut (#4).
Note: Tighten bolts snug but, do not over tighten.
Board Arms must pivot freely.
9.
If the two Tube Plugs (#9) are not already installed insert them
into open ends of Upper Arm (#6). It may be necessary to use a
rubber mallet to tap plug in.
12.
Slide Actuator Handle (#42) onto shaft on the bottom of
Actuator (#16). Line up hole in shaft with hole in Actuator
Handle and insert Pull Pin (#41) to secure.
See Figure 9
.
13.
To aid in the assembly of the backboard lower the backboard arms
by turning the Actuator Handle, until the lower arm makes
contact with the Safety Stop. See
Figure 9
.
PLACING THE POST ON THE ANCHOR SYSTEM
REQUIRES AT LEAST FOUR CAPABLE ADULTS.
POLE WILL WANT TO LEAN WHILE ATTEMPTING
TO STAND IT UP ON ANCHOR BOLTS.
Figure 6
6.
Secure Actuator Assembly to Lower Arm (#11) using one bolt
(#8), two flat washers (#3), four plastic washers (#5) and
one hex nut (#4). See
Figure 6
. Tighten both bolts (#8)
securing Lower Arm (#11).
Note: Tighten bolts snug but, do not over tighten.
Board Arms must pivot freely.
7.
If the two Tube Plugs (#10) are not already installed insert them
into open ends of Lower Arm (#11). It may be necessary to use
a rubber mallet to tap plug in.
Figure 7
42
41
Safety Stop
8
3
5
10
5
5
4
3
11
2
7
3
5
5
5
3
4
6
9
2
DRAIN HOLES
ON BOTTOM
BE SURE CONCRETE
HAS BEEN ALLOWED
TO CURE FOR AT
LEAST 3 DAYS
35
34
36
37
37
Figure 8
Note:
be used for leveling system.
See Step 11.
Bottom nuts #35 can
35
(Bottom Nut)
10.
Locate hardware needed to mount pole to anchor bolts. You
will need, eight flatwashers (#37), four lock washers (#36),
four hex nuts (#35) and four thread protectors (#34).
Note: Do not remove the nuts you installed in step 2 (pg. 5).
11.
Put a flat washer (#37) on each anchor bolt. Lift post onto
anchor system and secure with one flatwasher (#37), one
lock washer (#36) and one hex nut (#35) for each anchor
bolt. Tighten Fasteners finger tight, leave loose enough to
level pole. Place a level on pole and adjust bottom nuts
#35 front and back and side to side until pole is level.
Tighten top four hex nuts #35 tight. See Figure 8.
Figure 9
Summary of Contents for B3300W
Page 2: ...2...
